ATTACHING THE ARM ASSEMBLY TO THE WALL PLATE
It is easy to assemble the arm assembly to the wall plate. First, insert the arm
assembly’s shoulder into the wall plate’s rail side. Tighten the socket screws, as
in fig. 3.1. Recover the aluminium covers and the plastic covers, then tighten
Philips screws, as fig. 3.2.
INSTALLATION OF THE MONITOR BRACKETS TO THE BACK
OF THE DISPLAY
When you begin to install the display to the monitor brackets, you must select the
correct screws. Before installation, the adjustable bracket must be vertically placed.
The distance from the centre of the television to the brackets should be as short as
possible. If you have a television with a groove in the back, use the screws (C,E,G or
I), thread them through the square washers (B), the television mounting assembly and
then through the Spacer1 (L), and screw into the television. Finally, use the screwdriver
to tighten the screws firmly as shown in fig. 4.1.
With a television that has a recessed mounting area or a curved back, use the screws
(D,F,H or J), threading them through the square washers (B), the television mounting
and Spacer 1 (L), Spacer 2 (M), and thread into the television. Finally, tighten the
screws with a screwdriver firmly, as shown in fig. 4.2.
STEP 3
STEP 4
fig. 3.1
fig. 3.2
Using the template, drill holes with a diameter of 14mm (1/2”), to a depth of 90mm
(3 1/2”) into a solid portion of the cinderblock wall. These holes should be in a vertical
line. Using a level is recommended. Insert the anchors into the holes, and then lightly
tap them flush to the wall with a hammer. Attach the wall plate to the wall with lag
bolts. Make sure the wall plate is level and tighten all fasteners.
