23
Installation on a Wall Mounting
Before attaching the speaker system, make sure that the installation area can hold a minimum point load of
10 times the installation's weight (e.g. 13 kg weight - 130 kg point load). When installed on a wall mounting,
the speaker system must always be secured with a safety bond.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Installation on a Speaker Stand
The speaker system features a flange on the bottom for installation on a stand or speaker stand.
Caution!
Speaker systems installed on stands or satellite systems may cause severe injuries when crashing!
Stands or satellite systems must only be installed on a plane area with a maximum inclination angle of 5°.
When using stands or satellite systems under the influence of horizontal forces, e.g. through wind, the
standing safety can be impaired. This is why additional safety measures like attaching ballast weights have
to be taken.
The subwoofer and the top speaker must only be connected via an appropriate distance tube and flange.
The carrying capacity of the distance tube must never be exceeded.
A satellite system or a combination of speaker system/speaker stand or speaker system/stand must only be
installed on the ground! When choosing the installation spot, please make sure that such an installation has
to be installed in a way that no person can enter the area below the system! Make sure that the respective
area is blocked.
If inclined tension cables or prolonged outriggers are used, the area of danger has to be marked or even be
blocked.
Before lifting or lowering the telescopic tubes, you must always block a safety area around the stand or
satellite system. This safety area must have a diameter of 1.5 times the maximum height. Lifted telescopic
tubes always have to be secured with a secondary securing!
The total weight of the installation (=total weight of all individual parts) must never exceed the maximum load
of the installation area.
The stand has to be installed out of the reach of people. An unintended movement of the load has to be
avoided - also in case of fire!
The installer is responsible for adhering to the carrying capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personnel have to be instructed on the content of the user manual and on the dangers related with
operating stands.
Depending upon the individual installation spot, all necessary measures against movement and for securing
the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate substructure, e.g. via a
balancing foot, has to be created.
When choosing the installation material, optimum dimensions have to be chosen in order to secure
maximum safety.
If installing on slippery surfaces, the legs must be secured with screws or nails via the provided holes or an
anti-slippery mat has to be used.
