10006750_V_1_1.DOC
24/28
11. CUE-BUTTON
If you push this button it lights up and the channel signal is sent to the headphones. Slowly turn up the
headphones level control until you hear the music. The signal level is displayed on the CUE-LED METER.
12. CROSSFADER
Mixes the signals of one channel with another. If the crossfader is in the center-position, both channels can
be heard. With the ASSIGN-selectors, you can route the channels to the crossfader.
13. PHONO / LINE / MIC-SWITCH
Used to select the input to be sent to the individual channel. Make sure that the PH/LINE or LINE/MIC-switch
on the rear panel is set properly.
14. CUE MIXING-FADER
Connect your headphones to the HEADPHONES socket. With the CUE-buttons, you can select the desired
channel.
When you set the CUE MIXING-fader to MASTER, you can cue the output signal of the mixer.
When you set the CUE MIXING-fader to to the center position, you can cue both the channel-signal you
have selected and the output-signal.
When you set the CUE MIXING-fader to to CUE, you can cue the channel-signal you have selected.
15. MASTER 1-FADER
With the Master 1-fader, you can adjust the MASTER 1 output level.
16. CUE LEVEL-CONTROL
With the CUE Level-control, you can adjust the phones volume without changing the output signal.
17. HEADPHONES-SOCKETS
Use these sockets to connect the headphones via 6.3 mm and 3.5 mm mono-jack. Headphones from 8
Ohms to 600 Ohms can be used.
18. CUE SPLIT/CUE MIX-BUTTON
Cue Split-function (button pressed and Cue Split-LED illuminated): the Cue-signal is on the one side of the
headphones and the output-signal on the other side.
Cue Mix-function (button released): the adjustable mix of Cue-signal and output-signal is on both sides of the
headphones.
19. BOOTH LEVEL-CONTROL
With the Booth Level-control, you can adjust the level of the signal to the stereo booth monitor output. This
does not affect the level in the headphones.
20. MASTER 2-CONTROL
With the Master 2-control, you can adjust the MASTER 2 output level.
21. M1 / M2-SWITCH
Used to switch the display from Master 1 to Master 2.
22. DJ MIC TO REC-SWITCH
Press this button to route the DJ MIC to the REC socket in order to record the MIC signals as well.
23. REC OUT-SOCKETS
Additional RCA output sockets to connect your recording unit on the front panel. The ouptut level is not
affected by the master control.
24. LINE 10 INPUT-SOCKETS
Additional RCA and 3.5 mm mono-jack input sockets for CH-4/LINE 10.
Connect line sources like MP3-players via the 3.5 mm mono-jack socket. Make sure that the LINE/MIC-
switch is set to LINE.
25. EQ TO MASTER 2-SWITCH
Press this button and the EQ settings affect the MASTER 2 signal as well.
