27
2
Shortly press the button [
U/SD
] on the device or the button [
Mode
] on the remote control to switch
between the data carriers.
3
Adjust the desired volume with the level control [
LINE 1/MP3
]. Alternatively, you can use the buttons
[
VOL+
] and [
VOL-
] on the player (long actuation) [
+
] and [
‒
] on the remote control.
4
To interrupt the playback, press the button [►
]
(indication ”
PAUSE
“).
5
With the buttons [
] and [
], you can skip titles in forward or backward direction:
• short actuation of the button [
]
:
skip to the next title
• short actuation of the button [
]
:
skip to the previous title
6
For direct selection of a title with the numerical keys [
0-9
] on the remote control, enter its number.
Example: For title number 27 press keys [
2
] and [
7
].
7
With the buttons [
FOL-
] and [
FOL+
], you can select folder:
• short actuation of the button [
FOL+
]
:
skip to the next folder
• short actuation of the button [
FOL-
]
:
skip to the previous folder
8
With the button [
], you can activate continuous repeat of the selected title.
9
Press the button [
EQ
] on the remote control repeatedly to select an equalizer setting: „
CLASSICAL
“
„
BASS
“ „
LIVE
“ „
ROCK
“ or „
POP
“. When set to “
NORMAL
“, the frequency response is not affected.
10
For muting the sound, press the button [
]. The display indicates [
]. To switch on the sound
again, press the button once again. The indication [
] extinguishes.
11
Shortly press the button [
] on the remote control, to switch the display to clock indication.
During the clock indication, the adjusting mode for the clock can be activated by long actuation of the
button [
] (the hours are flashing). Use the buttons [
] and [
] to adjust the hours. Switch to
minutes with the button [
] (the minutes are flashing) and adjust the value with the buttons [
] and
[
]. Once again, press the button [
], to exit the adjusting mode.
12
To remove a USB device, disconnect it from the USB port. To eject a memory card, slightly press it into
the slot until it comes out and can be removed. Prior to removing a device, always terminate the
playback with the button [►
II
]. Otherwise damage or loss of data may occur.
Protective Circuits
The protective circuits prevent damage to the speakers and the amplifier. If activated, the speakers are
electrically separated from the amplifier and the LED [
FAULT
] lights up:
•
for a few seconds after switching-on until the speaker outputs are ready for operation
•
in case of a short-circuit at a speaker output
•
in case of over current
If the red LED [
FAULT
] lights up during operation or if it does not extinguish after switching on, the amplifier
has to be switched off and the cause of the fault has to be removed.