Omnitronic I-208, User Manual

Page: 28 / 39

00033329.DOC, Version 1.1 28/39
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personell has to be instructed on the content of the user manual and on the dangers related with
operating stands.
Depending upon the individual installation spot, all necessary measures against movement and for securing
the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate substructure, e.g. via an
balancing foot, has to be created.
The system must never be moved before the top speaker is uninstalled!
When choosing the installation material, optimum dimensions have to be chosen in order to secure
maximum safety.
Loosen the fixation screws of the legs. Pull the legs out until the cross struts stand at a 90° angle to the legs.
Tighten the fixation screws of the legs.
DANGER!
If installing on slippery surfaces, the legs must be secured with screws or nails via the provided
holes or a anti-slippery mat has to be used.
Installation of the TV-pin (only for stands)
Attach an appropriate TV-pin to the top end of the stand and fasten it with the handle at the side.
Suitable TV-pin: EUROLITE TV-35 TV-pin for speakers, No. 60000735
Installation of the speaker-system
Caution:
The loads have to be installed in a balanced way.
Caution: The carrying capacity of the stand or speaker stand must never be exceeded!
Install the speaker-system via the flange on the speaker stand or via the TV-pin on the stand.
Make sure that the maximum lifting height of the tube is never exceeded.
Lifted telescopic tubes always have to be secured with a secondary securing!
Installation on a wall-mounting
The speaker-system may only be installed on a wall-mounting if
the original speaker-system is equipped with an appropriate
flange.
When installed on a wall-mounting, the speaker-system must
always be secured with a safety bond.
Before attaching the speaker-system, make sure that the
installation area can hold a minimum point load of 10 times the
installation's weight (e.g. 13 kg weight - 130 kg point load).
The durability of the installation depends very much on the
material used at the installation area (building material) such as
wood, concrete, gas concrete, brick etc. This is why the fixing
material must be chosen to suit the wall material. Always ask a
specialist for the correct plug/screw combination indicating the
maximum load and the building material.