14
Keep away from heaters and other heating sources.!
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it
on immediately. The arising condensation water might damage your device. Leave the device switched off
until it has reached room temperature.
Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, disconnect
from mains immediately. Please let the device be checked by a qualified service technician before you
operate it again. Any damages caused by liquids having entered the device are not subject to warranty!
Never let the power-cord of the power-unit come into contact with other cables! Handle the AC-cord and all
AC-connections with particular caution!
Before the device is switched on all faders and volume controls have to be set to 0 or min position.
Please note that damages caused by manual modifications on the device or unauthorized operation by
unqualified persons are not subject to warranty.
Keep away children and amateurs!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
3. OPERATING DETERMINATIONS
You can install the device at any desired place. Please make sure that the device is not exposed to extreme
heat, moisture or dust. There should not be any cables lying around. You endanger your own and the safety
of others!
Do not operate the device in extremely hot (more than 30°C) or extremely cold (less than 5°C) surroundings.
Keep away from direct insolation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use spray cleaners in order to clean the faders!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
4. CONNECTIONS
• Make sure that the power switch is set to OFF. Before you connect the devices, all units have to be
switched off and the master control is set to 0.
• In order to obtain highest sound quality, only use high-quality cables for connecting the devices. Make sure
that the cables are properly fixed.
• Connect your amplifier to the MASTER OUT jacks. Make sure that the jacks are set properly (L & R).
• For recording, connect your tape recorder or cassette deck to the REC OUT jacks. The REC OUT level will
not be influenced by the master control. You can set the output level with the channel faders.
• The FX-120 features one controllable microphone channel. The microphone can be connected via the ¼"
mono jack plug on the frontpanel or on the rearpanel. With the Talkover-button, you can attenuate all other
signals without affecting the microphone volume.
