00039579.DOC, Version 1.1
23/26
5 SET UP
5.1 Installation
Install the unit on a plane surface or in your rack. For 19" (483 mm) rack installation, 2 units are required.
Screw on the two supplied mounting brackets at the left and right sides of the housing. When mounting the
unit into the rack, please make sure that there is enough space around the device so that the heated air can
be passed on. Steady overheating will damage your device. You can fix the unit with four screws M6 in the
rack.
5.2 Connections
S
Prior to making or changing any connections, switch off the
DMP-101
and the units to be connected.
S
Connect subsequent units with line level inputs (e.g. amplifier or mixer) to the balanced XLR output and/or
to the unbalanced RCA output. Make sure that the right/left occupation is the same at the devices. The
output volume can be adjusted with the control MUSIC LEVEL.
S
For connection of a microphone use the microphone input (3-pin XLR, bal.). The microphone volume can
be adjusted with the control MIC GAIN.
S
The input signals can be monitored ahead of the master control via stereo headphones. Connect the
headphones to the 3.5 mm jack PHONES on the front panel. The headphone volume can be adjusted with
the control PHONE LEVEL.
S
Connect the
DMP-101
to the mains.
If the device will be directly connected with the local power supply network, a disconnection switch with a minimum
opening of 3 mm at every pole has to be included in the permanent electrical installation. The device must only be
connected with an electric installation carried out in compliance with the IEC standards. The electric installation must be
equipped with a Residual Current Device (RCD) with a maximum fault current of 30 mA.
5.3 Remote control
S
To insert the batteries, remove the cover on the rear side of the remote control.
S
Insert two 1.5 V micro batteries (type AAA) as indicated in the battery compartment. Close the
compartment again with the cover.
S
If the remote control not used for a longer period (approx. 1-2 weeks), please remove the batteries to
prevent damage in case of battery leakage. Please refer to further explanations in chapter Safety
Instructions.
