25
Installation on a Stand or Speaker Stand
Stands or satellite systems must only be installed on a plane area
with a maximum inclination angle of 5°.
Caution:
Speaker systems installed on stands or satellite systems
may cause severe injuries when crashing!
When using stands or satellite systems under the influence of
horizontal forces, e.g. through wind, the standing safety can be
impaired. This is why additional safety measures like attaching ballast
weights have to be taken.
If inclined tension cables or prolonged outriggers are used, the area
of danger has to be marked or even be blocked.
Before lifting or lowering the telescopic tubes, you must always block
a safety area around the stand or satellite system. This safety area
must have a diameter of 1.5 times the maximum height.
Lifted telescopic tubes always have to be secured with a secondary
securing!
The total weight of the installation (=total weight of all individual parts) must never exceed the maximum load
of the installation area.
The stand has to be installed out of the reach of people.
An unintended movement of the load has to be avoided - also in case of fire!
The installer is responsible for adhering to the carrying capacity given by the manufacturer, the safety
requirements and the qualification of possible co-workers.
When people are located below the load, all necessary safety measures have to be taken in order to avoid
injury.
The personnel have to be instructed on the content of the user manual and on the dangers related with
operating stands.
Depending upon the individual installation spot, all necessary measures against movement and for securing
the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate substructure, e.g. via a
balancing foot, has to be created. When choosing the installation material, optimum dimensions have to be
chosen in order to secure maximum safety.
1
Attach an appropriate TV pin to the top end of the stand and fasten it with the handle at the side.
Suitable TV pin: EUROLITE TV-35 TV-pin for speakers, No. 60000735.
2
Loosen the fixation screws of the legs. Pull the legs out until the cross struts stand at a 90° angle to the
legs. Tighten the fixation screws of the legs.
3
Install the speaker system via the flange on the speaker stand or via the TV pin on the stand. Make
sure that the maximum lifting height of the tube is never exceeded. The carrying capacity of a distance
tube must never be exceeded.
DANGER!
If installing on slippery surfaces, the legs must be secured with screws or nails
via the provided holes or an anti-slippery mat has to be used.
