AX_TOP_SERIES.DOC
32/42
Installation on a stand or speaker stand
The speaker-system may only be installed on a stand or speaker stand if the original speaker-system is
equipped with an appropriate flange.
Stands or satellite systems must only be installed on a plane area with a maximum inclination angle of 5°.
Caution:
Speaker-systems installed on stands or satellite systems may cause severe injuries when
crashing!
When using stands or satellite systems under the influence of horizontal forces, e.g. through wind, the
standing safety can be impaired. This is why additional safety measures like attaching ballast weights have
to be taken.
If inclined tension cables or prolonged outriggers are used, the area of danger has to be marked or even be
blocked.
Before lifting or lowering the telescopic tubes, you must alway block a safety area
around the stand or satellite system. This safety area must have a diameter of 1.5
times the maximum height.
Lifted telescopic tubes always have to be secured with a secondary securing!
The total weight of the installation (=total weight of all individual parts) must never
exceed the maximum load of the installation area.
The stand has to be installed out of the reach of people.
An unintended movement of the load has to be avoided - also in case of fire!
The installer is responsible for adhering to the carrying capacity given by the
manufacturer, the safety requirements and the qualification of possible co-
workers.
When people are located below the load, all necessary safety measures have to
be taken in order to avoid injury.
The personell has to be instructed on the content of the user manual and on the
dangers related with operating stands.
Depending upon the individual installation spot, all necessary measures against
movement and for securing the standing safety have to be created.
The installation is only allowed on carrying areas. In some cases, an appropriate
substructure, e.g. via an balancing foot, has to be created.
The system must never be moved before the top speaker is uninstalled!
When choosing the installation material, optimum dimensions have to be chosen
in order to secure maximum safety.
Loosen the fixation screws of the legs. Pull the legs out until the cross struts stand at a 90° angle to the legs.
Tighten the fixation screws of the legs.
DANGER!
If installing on slippery surfaces, the legs must be secured with screws or nails via the provided
holes or a anti-slippery mat has to be used.
Installation of the TV-pin (only for stands)
Attach an appropriate TV-pin to the top end of the stand and fasten it with the handle at the side.
