1
Volume control CH1, CH2 and CH3
Volume control for the channels CH1, CH2 and CH3
2
Balance control
3
Volume control MASTER
Volume control for the main volume.
4
LINE/MIC switch
Switches between Line or Mic level.
5
MP3/STEREO input
3.5 mm input for external aoudio sources.
6
Volume control SUBWOOFER
7
MIC/LINE input
Balanced combo input (XLR/6.3 mm jack) for a microphone or audio sources with line level.
8
Line input
Stereo input (Cinch R/L) for external audoi sources with line level (e.g. CD player)
9
Signal input LEFT and RIGHT
Balanced combo input (XLR/6.3 mm jack) for connecting devices with line level.
10
Speaker connectors OUT/THRU
Feed-through output to connect other active speaker systems.
11
Mode selector switch
Switches between 2.1 and 1.1 mode with stacked satellites.
12
Left speaker outpu
Speaker jack for connecting the left column speaker.
13
Right speaker output
Speaker jack for connecting the right column speaker.
14
Voltage selector switch
15
Power switch
16
Fuse
Only replace the fuse when the device is disconnected from mains. Only use fuses of the same
rating and power. The correct fuse value is specified on the rear panel.
17
Power input
Plug in the supplied power cable here.
..............................................................................................................................................................................
5
INSTALLATION
The speaker systems can be mounted to a satellite system with the included telescope bar. For this, insert
the bar into the flange on the upper side of the subwoofer; then fasten the column module on top. The
column module’s lower speakers should be at ear’s height; adjust the telescope bar accordingly.
•
Always install the speakers at a solid, plane, anti-slip, vibration-free, oscillation-free and fire-resistant
location. Before installing the system, make sure that the installation area can hold a minimum point load of
5 times the system's load (e.g. weight 20 kg - point load 100 kg). The speakers must never be installed
higher than 100 cm without secondary attachment.
•
Satellite systems must only be installed on a plane area with a maximum inclination angle of 5°.
•
The stand has to be installed out of the reach of people. An unintended movement of the load has to be
avoided - also in case of fire!
•
Depending upon the individual installation spot, all necessary measures against movement and for
securing the standing safety have to be taken.
..............................................................................................................................................................................
Summary of Contents for ACS-600
Page 1: ......
