Omnitronic ACS-410BTS, User Manual

Page: 19 / 24

19
5
INSTALLATION
The speaker systems can be mounted to a satellite system with the included telescope bar. For this, insert
the bar into the flange on the upper side of the subwoofer; then fasten the column module on top. The
column module’s lower speakers should be at ear’s height; adjust the telescope bar accordingly.
•
Always install the speakers at a solid, plane, anti-slip, vibration-free, oscillation-free and fire-resistant
location. Before installing the system, make sure that the installation area can hold a minimum point load of
5 times the system's load (e.g. weight 20 kg - point load 100 kg). The speakers must never be installed
higher than 100 cm without secondary attachment.
•
Satellite systems must only be installed on a plane area with a maximum inclination angle of 5°.
•
The stand has to be installed out of the reach of people. An unintended movement of the load has to be
avoided - also in case of fire!
•
Depending upon the individual installation spot, all necessary measures against movement and for
securing the standing safety have to be taken.
..............................................................................................................................................................................
6
MAKING THE CONNECTIONS
Switch off the PA system and the units to be connected before making or changing the connections.
Audio Sources
As signal source, microphones and audio units with line level (e.g. smartphone, MP3 player, mixer) can be
connected.
•
Connect microphones to the input jacks of channels CH 1 and CH 2. Set the corresponding LINE/MIC
selector switch to position MIC.
•
There are several input jacks available for audio units with line level:
• Use input CH 1 and CH 2 for units with mono output (e.g. instrument preamplifiers). Set the
corresponding LINE/MIC selector switch to position LINE. Use input CH 3/4 for units with stereo output
(e.g. mixer).
• The AUX input is also designed for stereo signals.
Satellite Speakers and Monitor Speakers
•
Connect the satellite speaker to the SPEAKER OUT jack.
•
If a monitoring system is available, connect the amplifier of the monitoring system or the active monitor
speakers to the stereo output MONITOR OUT.
Connection to the Mains
Finally, connect the supplied power supply cable to the corresponding input and the mains plug to an outlet
(AC 230 V, 50 Hz).