b) TCP/IP – Setting
Before run with TCP/IP connection, pls make sure the IP address can match with
your network.
The IP address can be set through RS232 by following steps :
[1] Connect the reader with PC through RS232 .
[2] click on “connect” and select “R/W device config” as below :
[3] click “Query” to check the current IP address setting .
[4] If it is not match with your network setting, you can change the IP Address ,
Mask code & gateway
e.g 196.168.
000
.001 for Gateway
(need input 3 digit value / section e.g. “000”)
Below error message will be found , if input an incorrect format (e.g. “0” or “00”)
[5] click on “Set” to save after input the correct setting
[6] click on “Reset” to reset the reader to active the new setting
TCP/IP - connection
Connect the reader with the network hub through TCP/IP , then input the reader’s IP
address and port number (default 100).
Click
“
Connect
＂
button . If success , connect button will change to be gray color
and the information list will be shown as follow :
