OM9300F Technical Manual
Rev.
1.0
Document No.: 19B00270
Date: Jan 09, 2018
Page: 3
1. General Specifications
1.1 Printing Specifications
1) Printing method:
Thermal line printing
2) Dot density:
203dpi
×
203dpi. The number of dots per 25.4mm(1")
3) Printing direction:
Unidirectional with friction feed
4) Printing width:
75mm (2.83"), 576 dot positions
5) Characters per line:
Font A: 12 x 24 dots, or 48 CPL (default)
Font B: 9 x 17 dots, or 64 CPL
Chinese: 24 x 24 dots,
6) Printed dot dimension:
0.11mm
Î
0.13mm
7) Printing speed:
High speed mode:
65 lines/second maximum
(1/6inch feed) (at 24V, 20
℃
)
Approximately 200 mm/sec maximum
(approximately 8 inchs/sec maximum)
NOTE:
Speeds are switched depending on the applied voltage to the printer and
head temperature conditions automatically.
NOTE:
There may be variations in printing after switching the mode of the printing
speed. To prevent this for logo printing with
ESC*
command, using a downloaded bit
image is recommended. Change in printing speed does not occur during down loaded
bit image printing.
8) Paper feed speed:
Approximately 250mm/second
(approximately 12 inches/second)
(continuous paper feeding)
9) Line spacing (default):
1/6 inch (4.23mm)
Programmable by control command.
1.2 Character Specifications
1) Number of characters:
Alphanumeric characters:
95
Extended graphics:
128
×
7 pages
International code pages:
32
2) Font Definition:
Font A:
12
ⅹ
24 (Set as default)
Font B:
9
ⅹ
24
