Omnicomm LLS-AF 4, Manual

Page: 21 / 31

EN
20
Assembly instructions
Install the products according to the instructions of the
corresponding installation manual
http://www.omnicomm-world.com/documentation/hardware-/
fuellevel-sensors/installation-manuals/.
Assembly procedure:
1. Locate where to install the sensor
2. Prepare the tank for the installation
3. Cut the sensor probe according to the specific fuel tank
4. Setup the product with Omnicomm Configurator software
5. Fasten the sensor
6. Prepare wiring to connect the sensor to an external device
7. Sensor connection
8. Fuse installation
9. Calibration of the fuel tank
Location of product installation
Installation of a sensor depends on the geometry of the tank in
the place indicated in the diagram (Figure 1). Installation of sensor
in these areas ensures independence of the fuel level from the
inclination of the means of transport.
In cases, when it is impossible to perform the sensor installation in
the specified positions (Figure 1), the installation position must be at
least close to them.