Omnicomm LLS 5, Manual

Page: 30 / 39

EN
29
Electronic version
fuel level will be shown taking into account the current temperature.
“Network address” (1 to 254) – set the network address for the
Omnicomm LLS fuel level sensor. When several sensors are
connected to one external device, they should have unique network
addresses.
“Minimum level” (0 to 4094) – select the minimum reading for the
Omnicomm LLS 5 fuel level sensor. Default value – 0.
“Maximum level” (1 to 4095) – select the maximum reading for the
Omnicomm LLS 5 fuel level sensor. Default value – 4095.
“Filtration” – set the output signal filtration parameters:
• “No” – no filtration is performed. This option is used, when
filtration is carried out by external device
• “Minimum” – this filtration is used in case of the sensor installation
in stationary fuel storages and non-mobile machinery
• “Medium” – this filtration is used in case of vehicle’s operation in
normal road conditions
• “Maximum” – this filtration is used in case of vehicle’s operation in
severe road conditions
For automatic adjustment of Omnicomm LLS 5 sensor calibration
values, the fuel tank shall be filled in up to the top during the VH
operation. In case of full refueling of the tank, maximum length of
the measuring part not emerged into the fuel shall not exceed 10 cm
from the sensor flange.
When operating the VH with insufficient fuel level in the tank,
automatic adjustment cannot be carried out.