Omnicomm LLS 5, Manual

Page: 29 / 39

EN
28
Electronic version
Setting up the sensor with Omnicomm Configurator
Connect the sensor to the РС using USB adapter Omnicomm UNU-
USB in accordance with the User Manual.
“Empty/Full” Calibration
Perform calibration in the fuel, in which the Omnicomm LLS 5 fuel
level sensor will operate.
1. Fill the measuring container with fuel
2. Immerse the Omnicomm LLS 5 sensor into fuel to the full length of
the measuring piece
3. Wait for blue indicator “Stabilized” to appear. Click the “Full”
button, then the value corresponding to the full tank will be set
4. Take the Omnicomm LLS 5 sensor out of the container and allow
the fuel to flow down the measuring piece for 1 minute. Click the
“Empty” button, then the value corresponding to the empty tank
will be set
5. Click the “Save to sensor” button
General settings
“ Automatic adaptation ” – turn on for automatic adaptation of
measurements when dielectric permittivity of fuel is changed. When
switching the automatic adjustment on, changes in level caused by
fuel expanding under temperature impact will also be reflected, i.e.
The installed software is updated only when connected via RS-485
interface.