Omni Mixer, User Manual, Page: 5 / 12

Generator Probe Compatibility
Size
Processing
Range
Length Type
Resulting
Particle Size
Order No.
10 mm 1.5 mL - 100 mL
95 mm Saw Tooth Fine 15051
195 mm Saw Tooth Fine 150510
20 mm 50 mL - 2 L
100 mm Saw Tooth
Fine 15201
Coarse 15201W
145 mm Saw Tooth
Fine 15401
Coarse 15401W
195 mm Saw Tooth
Fine 15020
Coarse 15020W
30 mm 75 mL - 10 L 195 mm
Flat Bottom Fine 150-30NA-195
Flat Bottom
Wide Window
Coarse 150-30WA-195
45 mm
(Macro Only)
200 mL - 25 L 195 mm Flat Bottom Fine 150-45NA-195
55 mm
(Macro Only
300 mL - 30 L 195 mm Flat Bottom Fine 150-55NA-195
Generator Probe Installation
All generator probes (sold separately) are easily installed to the motor unit by following these steps:
1. Screw the generator probe adapter (P/N 15001) into the coupling adapter
2. Screw the generator probe into the generator probe adapter until the O-ring is completely inside
the generator probe adapter.
3. If the generator probe does not thread fully into the generator probe adapter, then unscrew the
generator probe from the generator probe adapter. Slightly rotate the rotor shaft collar on the
generator probe. Then return to step 2.
4. Tighten the generator probe by hand with moderate force.
5. Remove the blue protective cap from the tip of the generator probe and the homogenizer is ready
to operate.
NOTE: The tip of the generator probe, especially on the saw tooth generator probes, is sharp. For safety
purposes it is advisable that the protective cap be replaced on the generator probe when not in use.
NOTE: The bottom of the generator probe is extremely fragile and care should be taken to protect it.
Replace the blue protective cap on the end of the generator probe when the generator probe is not
being used.
WARNING : Never operate the motor with the generator probe (or sealed chamber assembly) partially
threaded onto the motor. To prevent damage to the motor and attachments be sure that the generator
probe (or sealed chamber assembly) is fully threaded into the coupling adapter. Failure to do so will
result in damage to the coupling system.