460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Roof Top Tent
Page
2
/
6
2.
Attach
ladder brackets to the base of
the
tent using M6 bolts. Bolt each ladder
bracket to the base of the tent through
the pre-drilled holes.
3. Mount the ladder brackets to the ladder
using the supplied M6 bolts, washers, plastic
washers, and nut. Plastic washers will go on
both sides of the bracket on the ladder.
Do not
over tighten bolts, there should be a slight
resistance when rotating the ladder.
Tech Tip
:
Thread locker is recommended for
these bolts as an extra measure for vibration
resistance.
1. Lay
the tent on its side on the ground. Using
the
supplied M6 bolts and washers, lift the
mattress
and insert the bolts into the pre-drilled
holes.
Align the aluminum rails with the
previously
installed M6 bolts through the floor.
Slide the
M6 nuts into the track and tighten the
bolts
from inside the tent.
Do not over tighten
hardware.
Tech Tip
:
We recommend using a blanket or
tarp when placing the tent on the ground to
keep the tent clean.
M6 Bolt
Washer
Tent Base
M6 Nylock Nut
Aluminum
Rails
The Aluminum Rails fitted to the base of the Roof Top
Tent with the slide plate and bolt fitted.
