Omicron CMC 310, User Manual

Page: 25 / 44

OMICRON 25
Technical data
4.4.3 Voltage outputs
Voltage outputs
Output voltages
3-phase AC (L-N)
1-phase AC (L-N)
1-phase AC (L-L)
DC (L-N)
3 × 0 ... 300 V
1 × 0 ... 300 V
1 × 0 ... 600 V
3 × 0 ... ±300 V
Typical Guaranteed
Output power
1
3-phase AC
2
1-phase AC (L-N)
1-phase AC (L-L)
DC (L-N)
1. Guaranteed data for ohmic loads (PF = 1). Refer to the accompanying figures of the output power curves.
2. Data for 3-phase systems are valid for symmetric conditions (0°, 120°, 240°)
3 × 100 VA at 100 ... 300 V
1 × 200 VA at 100 ... 300 V
1 × 275 VA at 200 ... 600 V
1 × 420 W at 300 V
DC
3 × 85 VA at 85 ... 300 V
1 × 150 VA at 75 ... 300 V
1 × 250 VA at 200 ... 600 V
1 × 360 W at 300 V
DC
Accuracy
3
3. rd. = reading; rg. = range, whereas n % of rg. means: n % of upper range value
Error <0.03 % of rd. + 0.01 % of rg. Error <0.08 % of rd. + 0.02 % of rg.
Harmonic distortion
(THD+N)
4, 5
4. Valid for sinusoidal signals at 50/60 Hz.
5. Values at 20 kHz measurement bandwidth, nominal value, and nominal load
0.015 % <0.05 %
Phase error
0.02° <0.1°
DC offset voltage <20 mV <100 mV
Voltage ranges Range I:
Range II: 0 ... 150 V
0 ... 300 V
Frequency ranges
6
6. For injections longer than 1 minute, the maximum fundamental frequency is limited to 587 Hz to comply with international
trade restrictions for frequency-controlled signal generators. For other options, please contact OMICRON Support.
Sinusoidal signals 10 … 599 Hz
Resolution Range I:
Range II: 5 mV
10 mV
Short-circuit protection Unlimited for L–N
Connection 4 mm sockets
Insulation Reinforced insulation of power supply and all SELV interfaces.