12
Power Switch
The Power Switch is located beside the battery holder. (See
Figure 2.1
.) It allows
for rebooting and shutting down the ZW-CM. You must reboot the ZW-CM to have it
rejoin the network if your Network ID or Device ID have changed or if a different RF
Frequency is selected. To reset the ZW-CM, turn the device OFF, wait 5 seconds and
then turn the device ON. The unit updates the Network ID and Device ID, enumerates
the internal sensors and searches for a Receiver.
Remove the Alkaline Batteries before long term storage of the ZW-CM.
Dimensions and Mounting
The ZW-CM includes all required hardware for mounting.To mount the ZW-CM,
position unit where required. Mark the location of the top center of the unit. Refer to
Figure 2.3
to mark and drill two pilot holes as indicated. Use the included drywall
anchors if needed. Open the lid of the ZW-CM to access the mounting points. Use the
included screws to secure the ZW-CM.
•
When mounting the unit be sure to leave room on the top to access the Power
button and on the bottom and side for the Probe and Antenna.
•
Mount the unit away from any large metal obstructions such as posts, catwalks,
or large machinery.
•
For best wireless range do not co-locate the ZW-CM with other 2.4GHz wireless
equipment such as wireless routers or access points.
•
For best wireless range elevate the ZW-CM and keep a direct line of sight the
Receiver.
Figure 2.3 – Mounting Dimensions
