Omega WRS232-USB, User Manual

Page: 10 / 24

2-1
Setup and Configuration
2
2 Setup and Configuration
Connect the wireless receiver module to the PC with USB cable provided. Fig.
2-1 shows the cable connection.
Figure 2-1 USB Cable Connections
2.1 USB Driver Installation
To install the USB software drivers that are required for your wireless receiver
to operate correctly follow these procedures.
You need to have the Software CD that was supplied with your device
loaded into the CD drive on your PC.
1. Connect the wireless receiver to your computer with the USB cable
provided in the box with your device. You should get a notice box that
indicates that your computer “Has Found New Hardware”
2. Your computer will then launch the Found New Hardware Wizard.
Follow the instructions indicated on the Wizard boxes and the additional
instructions noted in this manual.
After completing the Found New Hardware Wizard your system will
ask that you repeat this process. This is normal. You should repeat
the steps outlined here twice. After the second driver is installed you
should then get the “New Hardware Ready For Use” notice.
NOTE:
NOTE:
Connect to PC
Connect to Wireless
Receiver Module