Install Washer Dryer
3.Ensure the positioning status of washer dryer machine. Loosen the lock nut with spanner
and turn the leg with hand until it closely contacts with the floor. Press the leg with one
hand and fasten the nut closely to the cabinet with the other hand.
4.After being locked properly, press four corners again to make sure that they has been
adjusted properly. If it is still unstable, it has to repeat Steps 2 and 3.
Connect inlet pipe
Install inlet pipe
1.Connect the elbow to tap and fasten it
clockwise.
2.Connect the other end of inlet pipe to the inlet
valve at the backside of washing machine and
fasten the pipe tightly clockwise.
Notes: after connection, if there is any leakage
with hose, then repeat the steps to connect inlet
pipe. The most common type of tap shall be
used to supply water. If tap is square or too big,
then standard tap shall be changed.
Place outlet hose
There are two ways to place the end of outlet hose:
1.Put it beside the water trough.
5.Put a solid cylinder (e.g. pop cans) oppositely on the top cover of the washer dryer machine from
in the left, right, front and back directions. If the cylinder keeps stable, the washer dryer machine is
positioned level. If it rolls, the washer dryer machine is positioned unlevel. The rolling direction is the
direction of lower ground surface.Then, the two legs in this direction shall be raised at the same time
until the washer dryer machine is level. Steps 1~3 are repeated to make the bottom legs closely
against the ground and the nuts shall be locked tightly.
P.10
P.11
Install Washer Dryer
2.Connect it to the branch drain pipe of the trough.
Electrical Connection
- As the maximum current through the unit is 10A when you are using its heating function,
please make sure the power supply system (current, power voltage and wire) at your
home can meet the normal loading requirements of the electrical appliances.
- Please connect the power to a socket which is correctly installed and properly earthed.
- Make sure the power voltage at your place is same to that on the appliance data label.
- Power plug must match the socket and cabinet must be properly and effectively earthed.
- Do not use multi-purpose plug or socket as extension cord.
- Do not connect and pull out plug with wet hand.
- When connecting and pulling out the plug, hold the plug tightly and then pull it out. Do
not pull power cord forcibly.
M
ax
.1
00
cm
M
in
.6
0c
m
M
in
.6
0c
m
M
ax
.1
00
cm
Position outlet hose properly so that the floor will not be damaged by water leakage.
- Position outlet hose properly so that
the floor will not be damaged by water
leakage.
Trough
Hose Retainer
Bind
Max.100cm
Min.60cm
M
in
.6
0c
m
M
ax
.1
00
cm
- If outlet hose is too long, do not force
it into washer dryer machine as it will
cause abnormal noises.
Notes:
If the machine has outlet hose support, please install it like the following pictures.
Connect the cold water inlet pipe as
indicated in the diagram.
