![background image](http://html1.mh-extra.com/html/omega/ors6wxa/ors6wxa_instructions-for-the-use-and-care-and-installation_4077368007.webp)
INSTALLATION OF THE OMEGA ORS6WXA RANGE HOOD TO A CABINET
The diagram below shows the distance required between the holes in the top of the range hood. Due
to manufacturing procedures, it is recommended that the dimension be checked on the range hood
before installing. Please note that the exhaust air MUST flow through the opening at the top of the
range hood
, either via flexible ducting to the outside, or into the room through the cupboard itself
(using optional charcoal filters).
Drill the 6 x Ø4mm mounting holes & Ø130mm venting hole into the bottom of the cupboard. For a
ducted installation, drill a Ø120-Ø130mm hole for the ducting to exit. For a recycling installation, a
Ø120- Ø130mm hole should be cut out at the top of the cabinet to allow the exhaust to re-enter the
room.
Fit the one way valve onto the range hood.
Install the range hood to the bottom of the cupboard using the 35mm bolt supplied with the range
hood. The holes in the range hood are already threaded. Fully tighten the bolts. Install the flashing
plate supplied with the range hood, to the back of the range hood and underneath of the cupboard
using the 12mm screws. This is used to hide any gaps that may exist after fitting the range hood.
Ducting & charcoal filters can then be fitted (if needed) before the
range hood
is connected to the
power supply & turned on.
See diagram below for any clarification required.
OPERATING INSTRUCTIONS
Note: Before the
range hood
can be operated, it must
either be ducted or, if the model is installed as a re-
circulating range hood, it must be fitted with charcoal
filters. Connect the plug into the power.
Below is a diagram of the light and fan functions, with an
explanation of how the light and the fan functions
operate.
Retractable filter must be fully extended prior
to operation.
To operate the light, push the switch
①
into “I” position to switch the light on, or into “0” to turn
the light off. To operate the fan, push the switch
②
onto either:
I
– Low Fan Speed
II
–
High
Fan Speed
0 – To turn the fan Off.
If your range hood does not function correctly when attempting any of the above, please ensure that
your power is on and is functioning correctly. If the power seems to be functioning correctly in the
house, there may be a problem with the range hood. Please call your authorised service centre in this
case to organise a service call or replacement
range hood
.