Omega OMB-PER-488/W95, User Manual

Page: 13 / 144

Personal488 User's Manual For Windows 95 and Windows NT Personal488/ATpnp (with AT488pnp) 7
Personal488/ATpnp (with AT488pnp) 3
Introduction……7
The Package……7
AT488pnp Specifications……7
Controller Interface……7
Installing the New Hardware & Hardware Drivers……8
Updating the Existing Hardware Drivers……10
Introduction
The Package
The Personal488/ATpnp, including the IEEE 488 interface board and the Driver488 software, is
carefully inspected, both mechanically and electrically, before shipment. When you receive the
product, unpack all items carefully from the shipping carton and check for any obvious signs of
physical damage that may have occurred during shipment. Report any such damage to the shipping
agent immediately. Remember to retain all shipping materials in the event shipment back to the factory
becomes necessary.
The Personal488/ATpnp (with AT488pnp) package includes:
•
AT488pnp "Plug-&-Play" IEEE 488 Bus Interface ISA Board
•
Driver488 Software Disks for Windows 95 or Windows NT (Driver488/W95 or Driver488/WNT)
•
Personal488 User’s Manual for Windows 95 and Windows NT
AT488pnp Specifications
Note:
These specifications are subject to change without notice.
IEEE 488 Controller Device:
IOT7210
Maximum Transfer Rates:
16-bit DMA: 1 Mbyte/s (reads), 800 Kbyte/s (writes)
Dimensions:
Full-size board, two card edges; occupies one ISA slot
IEEE 488 Connector:
Accepts standard IEEE 488 connector with metric studs
Digital I/O Connector:
Standard 9-pin female DSUB connector
Power:
1.0 A max @ 5 V from PC
Environment:
0 to 70
°
C, 0 to 95% RH, non-condensing
DMA:
16-bit DMA on channels 5, 6, and 7
Interrupts:
IRQ 3, 4, 5, 7, 10, 11, 12, or 15
Digital I/O:
Each signal can source 2 mA @ 3.7 V (6 mA @ 3.2 V) and sink 2 mA @ 0.4 V (6 mA @
0.9 V)
Multiple Boards:
Up to three AT488pnp boards can be installed into one PC
Controller Interface
The AT488pnp interface board provides the convenience of plug-and-play installation. The physical
configuration of hardware is not necessary. Instead, after installing your board as described in the
following text, the board is configured automatically.