Omega OFDF462X, Instruction Manual

Page: 14 / 18

14
Operation Instruction
Cleaning the Interior and the Exterior of the Unit
Warning: Unplug the refrigerator for defrost and cleaning.

Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect and
energy saving.

Check the door gasket regularly to make sure there is no debris. Clean the door gasket with a soft cloth
dampened with soapy water or diluted detergent.

The interior of the refrigerator should be cleaned regularly to avoid odor.

Please turn off the power before cleaning interior, remove all foods, drinks ,shelves, drawers, etc.

Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons of baking soda and a
quart of warm water. Then rinse with water and wipe clean. After cleaning, open the door and let it dry
naturally before turning on the power.

For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or corners), it is
recommended to wipe them regularly with a soft rag, soft brush, etc. and when necessary, combined with
some auxiliary tools (such as thin sticks) to ensure no contaminants or bacterial accumulation in these areas.

Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the interior of the
refrigerator or contaminated food.

Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or diluted detergent.
Dry with a soft cloth or dry naturally.

Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy water, detergent, etc., and
then wipe dry.

Do not use hard brushes, clean steel balls, wire brushes, abrasives(such as toothpastes), organic solvents
(such as alcohol, acetone, banana oil, etc.), boiling water, acid or alkaline items, which may damage the fridge
surface and interior. Boiling water and organic solvents such as benzene may deform or damage plastic parts.

Do not rinse directly with water or other liquids during cleaning to avoid short circuits or affect electrical
insulation after immersion.
Cleaning of freezer drawer partition
1. Remove partition:
Pull out partition, pressing inner wall of drawer with one hand and pulling the middle partition out with another hand.
2. Install partition:
Press partition slowly down the slot until you hear a click.
There are two slots in the drawer for your option.