13
APPLIANCE U S E A N D MAINTENANCE
ATTENTION: Important Warnings.
For cookers resting on base
ATTENTION: if the cooker rest on a base, take the measures necessary to prevent the cooker from sliding along the support
base.
For cookers with electric ovens
ATTENTION: The unit becomes hot during use. Do not touch the heating elements inside the oven.
ATTENTION: The accessible parts can become hot during use. Keep children away from the appliance.
For glass doors
ATTENTION: Do not use harsh abrasive cleaning products or metal spatulas with sharp edges to clean the oven door’s glass
since this could scratch the surface and the glass could break.
For gas cooktops
ATTENTION: Clean burner tops and trivets at least once a week, or after any spillage. Gas inlet pipes should be checked
periodically for leakages (see section on leak testing), at intervals not exceeding 12 months. Lubrication of valves should only be
performed by an authorised person, and is required if the gas control knobs become stiff and difficult to turn.
Do not use steam cleaner to clean the appliance.
WARNING: DO NOT MODIFY THIS APPLIANCE
Please maintain your appliance regularly.
REPLACING PARTS
Before p e rf o r m i n g any maintenance operations, disconnect the appliance f r o m t h e g a s supply and electricity
network.
To replace parts such as knobs and burners, just remove them from the seats without dis assembling any part of the
cooker.
To replace parts such as nozzle supports, valves and electric components follow the procedure described in the burner
adjustment paragraph. To replace the valve or the gas thermostat, it is also necessary to disassemble the two rear gas train
brackets, loosening the 4 screws (2 per bracket) that attach it to the rest of the cooker and, unscrew the nuts that attach the
front burner valves to the control support, after removing all the knobs. To replace the gas or electric thermostat, also
disassemble the rear cooker guard, loosening the relative screws, to be able to pull down and reposition the thermostat bulb.
To replace the oven bulb, just unscrew the protection cap that projects out inside the oven (Fig.16)
Fig.16
WARNING:
Before replacing the bulb, disconnect the appliance from the electric power supply.
WARNING:
The power cord supplied with the appliance is connected to the appliance with an X type connection (in
compliance with standards AS/NZS 60335-1, AS/NZS 60335-2-6 and subsequent amendments) for which it can be
installed without the use of special tools, with the same type of cord as the one installed.
If the power cord becomes worn or damaged, replace it based on the information reported in table 2. To replace the
power cable, lift the terminal board’s cover and replace the cable.
