16
Cleaning the appliance
Before each cleaning disconnect the cooker from the electricity. To assure the long
life of the appliance, it shall be thoroughly cleaned frequently.
Wait until the oven has cooled before removing the wire shelves wash them
separately in warm soapy water and dry thoroughly.
Wash the interior of the oven with hot soapy water and wipe down with a damp
cloth.
Leave the door open until the interior has dried before replacing the wire shelves.
Clean the oven after each use especially after roasting or grilling this will prevent spilt
or splattered food debris burning and becoming difficult to remove.
Do not use abrasive pads to clean the interior of the oven as this may remove the
enamel, which will affect the efficiency of your oven.
Do not use harsh, abrasive cleaners or sharp metal scrapers to clean the oven door
glass or the cooktop since they can scratch the surface which may result shattering
of the glass.
You should regularly wipe over the control panel oven door and oven sides using a
soft cloth and mild liquid detergent as spilt liquids may damage the enamel.
Wash enamelled or chrome plated parts of the oven with warm soapy water or with
nonabrasive detergents. Never use abrasive pads to clean enamelled, chromed or
stainless steel surfaces.
When using commercially available stainless steel cleaning products avoid cleaning
any lettering or symbols, as they can become damaged.
The oven comes with catalytic panels for easier cleaning. They are coated in a
special, micro-porous catalytic enamel which oxidises and gradually vaporises
splashes of grease and oil at cooking temperatures above 200° C .If the oven is not
clean after cooking fatty foods, operate the empty oven for 60mins (max.) at
maximum temperature on function fan forced or fan assist.
Never wash or clean self-cleaning panels with abrasive, acid, or alkaline products.
Dust any residue off the cold panels every month or so to keep them working at
maximum efficiency.
To remove the wire side shelves, use a screwdriver to remove the bottom positioning
screw and rotate out of the holes in the oven sides. To replace, repeat process in
reverse.
To remove the catalytic panels (on both sides), first remove the wire side shelves.
Use a screwdriver to remove the positioning screw at the bottom of the catalytic
panel and rotate up out of the top positioning brackets. Replace by repeating the
process in reverse.
Summary of Contents for OF694CX
Page 2: ...2 ...
Page 20: ...20 Wiring diagram ...