Omega ODW715X, Instruction Manual

Page: 29 / 31

26
Troubleshooting
Problem Possible Causes What to Do
White film on inside
surface
Hard water minerals
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
There are rust
stains on cutlery The affected items are not
corrosion resistant
The items should be corrosion resistant.
Knocking noise in
the wash cabinet A spray arm is knocking
against an item in a basket Interrupt the program, and rearrange the items
which are obstructing the spray arm.
Rattling noise in the
wash cabinet Items of crockery are loose
in the wash cabinet Interrupt the program and rearrange the items of
crockery.
Knocking noise in
the water pipes
This may be caused by on-
site installation or the
cross-section of the piping.
This has no influence on the dishwasher function. if
in doubt, contact a suitably qualified plumber.
The dishes are not
clean
The dishes were not
loaded correctly.
See notes in " Loading the Dishwasher Baskets ".
The program was not
powerful enough. Select a more intensive program. See" Wash Cycle
Table ".
Not enough detergent was
dispensed.
Use more detergent, or change your detergent.
Items are blocking the path
of spray arms Rearrange the items so that the sprayer can rotate
freely.
The filter combination is not
clean or is not correctly
fitted. This may cause the
spray arm jets get blocked.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the Spray
Arms".
Cloudiness on
glassware Combination of soft water
and too much detergent.
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Black or grey marks
on dishes Aluminium utensils have
rubbed against dishes. Use a mild abrasive cleaner to eliminate those
marks.
Detergent left in
dispenser cups Dishes block detergent cup
opens.
Re-loading the dishes properly.
The dishes are not
drying
Improper loading Load the dishwasher as suggested in the directions.
Too little rinse-aid
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Dishes are removed too
soon
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam
can escape. Begin unloading the dishwasher only
once the dishes are barely warm by touching. Empty
the low basket first. This prevents water from
dropping off dishes in the upper basket.
Wrong program has been
selected
In short program the rinse temperature is lower. This
also lowers cleaning performance. Choose a
program with a long high rinse temperature.
Use of cutlery with a low-
quality coating
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.