Timer Function
The timer function differs from the Minute Minder function in that it will turn off a cooking
zone at the end of the time. It can be set for one or more cooking zones (each working
independently). The Cooking Zone Select touch control & Power LED display always shows the
shortest timer when in operation.
1.
First set up the
Cooktop
with cookware placed on cooking zones and set all power levels.
2.
Activate a cooking zone pressing its Cooking Zone Select touch control & Power LED
display and within 10 seconds press the Timer Touch Control & LED display (11). The LED
shows the current timer value (00 if new).
3.
Set the time in the same manner as for the Minute Minder (the difference to setting the
Minute Minder function time is that the decimal point of the display (12) for the selected
cooking zone is also flashing). The timer starts as the last button is pressed. 3-10 seconds
after the last button is pressed, the decimal point on the Cooking Zone Timer Select
Indicator (12) will stop flashing and stay on as long as the timer is working. Another timer
function can now be set on a different cooking zone, or power levels can be adjusted.
4.
If a change needs to be made to a timer, the above can be repeated. Changing the value to
“00” will disable the timer on the selected cooking zone (but not the power level).
5.
When a timer function finishes, the
Cooktop
will start to beep indicating the cooking zone
has finished. The Cooking Zone Timer Select Indicator (12) for the cooking zone will flash
and the Timer Touch Control & LED display (11) LED will flash “00” for 2 minutes (unless a
button is pressed) and then the displays will return to normal. Any other timer functions that
are running will continue (Cooking Zone Timer Select Indicator decimal points on) until the
next timer is finished. If all timer functions finish and there are no other cooking zones
active, the
Cooktop
will return to the Stand-By-Mode after the alarm finishes.
Auto Cooking Function
The Auto Cooking Function allows you to set any or all cooking zones up so that they run at
a high power level for a period of time, and then drop the power down to a lower level.
1.
The
Cooktop
must be in set to Operating-Mode and the cooking zone selected.
2.
Use the Power/Timer Slide touch control (05) to set the power to “9”.
3.
Let go of the sensor and then press (+) again (the Cooking Zone Select touch control &
Power LED display changes to “A”). Holding down the sensor, slid the sensor back to the
left
to set a low power setting. After 5 seconds, the Select touch control & Power LED
display
will alternate between “A” and the low power setting. At this point, the cooking zone
will run
for a set time at high, and then drop down to the low power setting (at which point
the
Cooking Zone Select touch control & Power LED display changes to the low power
setting).
See table for times on next page.
4.
To disable the Auto Cooking Function, select the cooking zone and pick a new power
setting.
8
Bridge Function
The Bridge Function allows you to join the two cooking zones on the left hand size of the
cooktop.
1.
Turn on the cooktop using the On/Off
touch control.
2.
Pres
s
and hold both Cooking Zone
select touch controls for the left hand side cooking
zones.
3.
The bridge function becomes active when only the front
cooking zone power display is
illuminated.
4. To stop the bridge function, press and hold both Cooking Zone select touch controls for the
left hand side cooking zones.
