6
7
Catalogue
Installation
Installation Position
Level Adjusting
Once in its permanent operating position,
check that the dryer is absolutely level with the aid
of a spirit level. If it is not, adjust the feet with a tool.
Power Supply Connection
1.Make sure that the voltage of the power supply is the same as the electric specification of the dryer.
2.Do not connect the dryer with the power connection board, the universal plug or socket.
1.It is recommended that, for your convenience, the machine is positioned close to your washing
machine.
2.The tumble dryer must be installed in a clean place, where dirt does not build up. Air must be able
to circulate freely all round the appliance. Do not obstruct the front air inlet or the air intake grilles
at the back of the machine.
3.To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm
and level surface.
4.The feet must never be removed. Do not restrict the floor clearance through deep pile carpets,
strips of wood or similar. This might cause heat built-up which would interfere with the operation
of the appliance.
used as the handle for delivery. If the dryer can’t be transported erect, the dryer could be slant
Transport
Move cautiously. Do not grasp any salient parts of machine. The machine
door can not be
to right less than 30° .
Attention and Advice
1.Before drying, thoroughly spin the laundry in washing machine. High spin speed can reduce the drying
time and save energy consumption.
2.For uniform drying result, sort the laundry according to fabric type and drying programme.
3.Before drying, please close zips, hooks and eyelets, button up, tie fabric
belts, etc.
4.Do not over dry the clothes, because over dried clothes can easily get
creases or shrinkage.
5.Do not dry the articles containing rubber or similar elastic materials
such as raincoats, bicycle covers and
6.The door can be opened only after the programme of the drying
machine is completed. Do not open the
7.Clean the lint filter and empty container after each use to avoid extension of drying time and energy
9.The weight references as follows:
Blended Coats
(about 800g)
Jackets (about
800g in cotton)
Towel Quilts
(about 900g
in cotton)
Shirts (about
300g in cotton)
Work Clothes
(upper and lower)
(about 1120g in
cotton)
Underpants
(about 70g in
cotton)
Undershirts
(about 180g in
cotton)
Single Sheets
(about 600g in
cotton)
Jeans Trousers
(about 800g)
Pajamas
(about 200g)
Socks (about 30g in
blended material)
consumption.
Attention
etc.
door before the programme finished, as the skin
may be scalded by steam or hot surface.
Advice
a)Put some clean rags into the drum.
b)Plug the power, press
.
【
On/Off
】
c)Select the
【
Refresh
】
Programme, press
【
Start/Pause
】
button.
d)After finishing this programme, please follow the “cleaning and routine maintenance” (refer to page 15)
to clean the filter door.
Leave it to stand for 2 hours after transporting. Before first use, please use the soft fabric to
to clean the inside drum.
8 .. Please choose the related programme when deal with wool material clothes,
to make the cloth more fresh
. and fluffy.
During drying, the compressor and the water pump generate some
noise which is entirely normal
.
