Omega OCC30TZ, Installation, Operation And Maintenance Instructions

Page: 11 / 12

9
Installation
Cut out the work surface according to the
sizes shown below.
A minimum of 50mm must be left between
the edge of the hole and any edge of the
work surface. The work surface must be at
least 30mm thick. Take care that the
material of the work surface is heat resistant
to at least 100ºC to avoid any damage to the
work surface.
A – 268 to 272mm.
B – 500 to 504mm.
C, D, E, F – 50mm minimum.
Make sure the ceramic cooker hob is well
ventilated and the air inlet and outlet are not
blocked. Follow the following dimensions:
Note: The safety distance between the
cooktop and the cupboard above the
cooktop should be at least 760mm, and
between the cooktop and rangehood must
be a minimum of 650mm.
A – 760mm minimum to overhead cupboard,
650mm minimum to range hood.
B – 50mm minimum.
C – 30mm minimum.
D – Air intake.
E – 10mm x length of cooktop air exit.
Place the cooktop on a flat clean surface (for example part of
the carton). Loosely fit the rear 2 mounting brackets. Slide the
cooktop into the hole and fit the front 2 mounting brackets.
Adjust the position of the cooktop so it is central within the hole
and tighten all brackets.
ELECTRICAL CONNECTION:
Installation is only permitted by a licensed electrician, and
carried out according to instructions provided by the
manufacturer. Incorrect installation might cause harm and
damage, for which the manufacturer accepts no responsibility.
Before carrying out the connection to the power supply, the voltage rating of the appliance (stamped on the
appliance identification plate) must be checked for correspondence to the available mains supply voltage, and the
mains electric wiring should be capable of handling the oven’s power rating (also indicated on the identification
plate).
After having installed the appliance, the switched outlet must always be in an accessible position.
The cooktops are to be connected to a single phase 220-240Vac 50 Hz supply and earthed via the 15A plug. The
mains terminal is on the underside of the cooktop (this should be fully closed after installation).
During installation, an all pole disconnector should be included inside they supply circuit with a contact opening of
at least 3mm. The power supply cord must not touch against any hot surfaces and must be placed so that its
temperature does not exceed 75 °C at any point along its length. The electrical safety of this appliance can only be
guaranteed if the oven is correctly and efficiently earthed. The manufacturer declines all responsibility for damage
resulting from an installation which has not been earthed correctly.