![background image](http://html1.mh-extra.com/html/omega/hhm-ma640/hhm-ma640_user-manual_4153977010.webp)
MA640 V2.1 07/08
9
Data Hold
To freeze the LCD reading, press the
HOLD
button. While data hold is active, the
HOLD
icon appears on the LCD. Press the
HOLD
button again to return to normal operation.
MAX/MIN
1. Press
the
MAX/MIN
button to activate the MAX/MIN recording mode. The display icon
"
MAX
" will appear. The meter will begins recording and displaying the maximum
value measured.
2. Press
the
MAX/MIN
button and “
MIN
” will appear. The meter will display the minimum
value measured during the recording session.
3.
To exit MAX/MIN mode press and hold the
MAX/MIN
button for 2 seconds.
RANGE
In the Voltage, Resistance, Frequency or Temperature function the meter automatically
selects the best range for the measurements being made. For measurement situations
requiring that a range be manually selected, perform the following:
1. Press
the
RANGE
button. The “
AUTO”
display icon will turn off.
2. Press
the
RANGE
key to step through the available ranges. Observe the decimal
point and units displayed until the preferred range is located.
3.
To exit the Manual Ranging mode and return to Autoranging, press and hold the
RANGE
key for 2 seconds.
LCD Backlight
The LCD is equipped with backlighting for easier viewing, especially in dimly lit areas.
Press and hold the
HOLD/
button for 2 seconds to turn the backlight on. The backlight
will automatically turn off after 5 seconds.
Automatic Power OFF
In order to conserve battery life, the meter will automatically turn off after approximately 15
minutes of operation. The meter will beep shortly before the meter shuts off. If a button is
pressed, the APO timer will reset. If the meter is allowed to shut off, turn the function
switch to the OFF position and then to the function again to restart.
Low battery indication
When the
icon appears in the display, the battery should be replaced. Refer to the
battery replacement procedure in the maintenance section.