Page - 25
2 seconds after the ignition switch is turned "on", and unlock instantly when the ignition
switch is turned "off".
4) Open Door Bypass to Feature #3: If feature #4 is "on" the system will check the vehicle's
door circuit. If it detects that any of the vehicle's doors are open at the time, the doors will not
automatically lock when the ignition switch is turned "on", nor automatically unlock when the
ignition switch is turned "off".
5) 30 or 60 Second Activation Duration: Feature #5 will select the length of time that the
siren sounds and the lights flash when the alarm is activated or triggered. This can be used
when local law requires shorter siren times for noise restrictions. Pressing the small transmitter
button when programming this Feature will select the 30 second timing cycle.
6) Double Pulse Door Unlock: If Feature #6 is "on" the alarm's unlock output will pulse
twice to unlock some of the newer doorlocking systems.
7) Steady Siren Or Pulsed Horn Output: Instead of the siren, if the vehicle's horn is
preferred, this Feature changes the output from steady to pulsed, allowing the use of the horn
for the alarm's audible responses. If the vehicle does not utilize an existing horn relay, one must
be added or this output's 1 Amp capacity may be exceeded, which will damage the alarm. This
Feature is defaulted to Pulsed Horn, but set for Steady Siren at the factory.
8) Horn Confirmation Honk Loud Or Soft: When the previous Feature is set for Pulsed
Horn, the arming and disarming confirmation honks may be adjusted with this
Page - 26
Feature. When programming this Feature, pressing the large transmitter button will select
a longer output pulse, which will make the confirmation horn honk louder.
9) Open Door Arming Alert: When this Feature is utilized, if one of the vehicle's doors
is open when the system is armed using the transmitter, the siren will chirp (or the horn will
honk) 3 times instead of once upon arming the alarm.
10) Transmitter Activated Anti-Carjacking: This Feature adds Anti-Carjacking
protection, and the ignition must be "on" for the Anti-Carjacking to operate. Press and hold
both transmitter buttons for 3 seconds. The siren will start chirping 53 seconds later, and for
the next seven seconds pressing the Valet Switch once will cancel the Anti-Carjacking Feature.
At 60 seconds the siren will fully sound, and the parking lights will also flash. At 90 seconds
the starter interrupt output will activate. Once the siren sounds and parking lights
flash, Anti-Carjacking cannot be canceled unless the ignition is turned "off", then back "on";
the Valet Switch must be pressed once within 10 seconds of turning the ignition back "on".
This is the only way to cancel or turn off the Anti-Carjacking Feature - once activated, the
transmitter cannot be used to cancel or turn off the Feature.
Up to 4 different transmitters may be programmed into the security system's memory. When
a new transmitter code is programmed into the system, all previous codes will be deleted. If
a third or fourth transmitter is desired, all of the transmitters must be programmed into system's
memory. To program transmitters to operate your system, follow this process:
Programming Transmitters
1)Turn "on" the ignition switch.
2)Within 5 seconds of turning "on" the ignition switch, press the Valet Switch 5 times.
Note: The system will respond with a long siren chirp or horn honk, confirming that it is
ready to learn a transmitter code. If a code is not received or the ignition is turned "off",
the learning process will automatically terminate, which will be indicated by two siren
chirps or horn honks. When the first transmitter code is learned, all other prior codes will
be erased.
3)To learn the first transmitter code, press the large transmitter button, (which will arm/disarm/
panic the system), until you hear one long and one short siren chirp or horn honk to confirm
that the code was learned. The two small button's functions will automatically be learned
at the same time.
4)To program the second, third or fourth transmitter codes, repeat step 3. As each transmitter
is learned, the long confirmation siren chirp or horn honk will be followed by two short chirps
or honks for transmitter number two, three short chirps or honks for transmitter number three,
and four short chirps or honks for transmitter number four. An attempt to add any further
transmitter codes will be ignored.
5)Turning off the ignition switch or 10 seconds of no programming will turn off the transmitter
learning program, which is confirmed by two long siren chirps or horn honks.
Whenever a transmitter is coded into the system, whether an existing one or previously
unknown transmitter, the siren will chirp or the horn will honk for two seconds every time the
ignition is turned "on", for 48 hours. Additionally, the LED Status Light will flash the number
of transmitters which can operate the system for 90 seconds instead of 10 seconds.
Page - 27
MO_EG-1200ATV.REV2
This device complies with FCC Rules part 15. Operation is subject to the following two
conditions, (1) This device may not cause harmful interference and, (2) This device must
accept any interference that may be received, including interference that may cause undesired
operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate
the equipment.
L I M I T E D L I F E T I M E W A R R A N T Y
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the Company), are
warranted to be free from defects in materials and workmanship under normal use. If a product sold by the Company
proves to be defective, the Company will repair or replace it free of charge within the first year and thereafter all parts
to be repaired will be free with only a nominal charge for Omega Research and Development, Inc.'s labor and return
shipping, to the original owner during the lifetime of the car in which it was originally installed.
All products for warranty repair must be sent postage prepaid to Omega Research & Development, Inc., P.O.
Box 508, Douglasville, Georgia 30133, with bill of sale or other dated proof of purchase. This warranty is nontransferable
and does not apply to any product damaged by accident, physical or electrical misuse or abuse, improper installation,
alteration, any use contrary to its intended function, unauthorized service, fire, flood, lightning, or other acts of God.
This warranty limits the Company's liability to the repair or replacement of the product. The Company shall
not be responsible for removal and/or reinstallation charges, damage to or theft of the vehicle or its contents, or any
incidental or consequential damages caused by any failure or alleged failure of the product to function properly. Under
No Circumstances Should This Warranty, Or The Product Covered By It, Be Construed As A Guarantee Or Insurance
Policy Against Loss. The Company neither assumes nor authorizes any person or organization to make any Warranties
or assume any liability in connection with the sale, installation, or use of this product.
