![background image](http://html1.mh-extra.com/html/omega/dtg-rtd100-series/dtg-rtd100-series_user-manual_4100292014.webp)
USB connector
USB programming cable location on your meter
Figure 3-7. USB Programming Cable
Figure 3-8. USB Connector Location
Connect the A-type connector to your PC and then connect the B-type connector
to the USB port on your meter.
Setting Up Your Meter
Now that you have connected your USB cable to your PC and to your meter, you
can now complete the following steps to configure your meter before placing
the unit into operation. You will be using the configuration software utility that
you installed onto your PC. If you have not installed the configuration software
utility you should do so now.
STEP 1. Launch Setup Utility Program.
To launch the setup utility program on your PC begin by finding and clicking
on the DTG program Icon that was placed on your computer desk top when you
installed the software.
Figure 3-9. Launch Setup Utility Screen
Setup & Configuration
3
3-5
USB
ON/OFF
SWITCH
A-TYPE
CONNECTOR
B-TYPE CONNECTOR