3.2.12 Output 2 Menu
Output 2 and Alarm 2 share the same contacts on the rear panel connector. If
Alarm 2 is
Enabled
, Output 2 is automatically
Disabled
.
Figure 3.10 Flow Chart for Output 2 Menu
ENTER OUTPUT 2 MENU:
Press
a
1)
Press
a
, if necessary, until
CNFG
prompt appears.
Press
d
2)
Display advances to
INPT
Input Menu.
Press
a
3)
Press
a
, if necessary, until Display advances to
OUT2
Output 2 Menu.
Press
d
4)
Display advances to
CTRL
Control Type Submenu.
CONTROL TYPE SUBMENU:
Press
d
3)
Display flashes
ON.OF
On/Off, or
PID
PID.
Press
b
4)
Scroll through the available selections: “ON.OF” or “PID”.
Press
d
5)
Display shows
STRD
stored message momentarily and then
advances to
AçTN
only, if it was changed, otherwise press to
advance to
AçTN
Action Type Submenu.
The
ON.OF
control is a coarse way of controlling the Process. The “Dead Band”
improves the cycling associated with the ON.OF control. The
PID
control is best
for processes where the set point is continuously changing and/or tight control of
the Process Variable is required.
43
It
is required that you put
the controller in the
Standby Mode for any
configuration change other
than Set Points & Alarms.
Summary of Contents for CNiS16
Page 69: ...NOTES 65...
Page 70: ...NOTES 66...
