3
PRePARAtIOn
Assembly
(Refer to Figure 1)
estimated Assembly time:
20 minutes.
tools Required for Assembly:
Large Philips screwdriver, 19mm wrench, socket wrench and torque wrench.
1. Package contents:
(a) Hydraulic unit,
(b) Saddle unit,
(c) Base half - two (2) pieces,
(d) Caster - four (4) pieces,
(e) Saddle bracket & bracket bar - four (4) sets,
(f) Position handle, and
(g) Hardware
2. Attach all four casters to the base halves and secure with washers and M12 locknuts.
3. Attach either one of the two base halves to the base of the hydraulic unit, then secure using M12x70 bolts and
lock washers. Apply the same procedure to the other base half. Use torque wrench to tighten to 30 lb.ft.. Do not
overtighten.
4. Attach the position handle onto Hydraulic unit with M10x40 bolt and locknut.
5. Position the saddle unit above the ram plunger, place the saddle socket onto the ram plunger. Secure with two
M12x20 bolts provided.
6. Secure all four bracket bars to the saddle with M12x40 screws and wing nuts. Then attach saddle brackets onto
the bracket bars with M10 nuts.
Before Use
1. Verify that the product and the application are compatible, if in doubt call Omega Technical Service (888) 332-
6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the potential hazards associated with its use.
3. Press the release valve pedal, ensure that saddle is fully lowered. Remove shipping plug (shipping plug is
located above the oil filler plug). Ensure oil level is just below the rim of the oil filler hole.
Reinstall
with
vent plug
provided.
4. Check to ensure that jack rolls freely, that the pump and release valve operate smoothly. Raise and lower the
unloaded jack throughout the advertised lift range before putting into service.
5. Replace worn or damaged parts and assemblies with
Factory Authorized Replacement Parts only.
Lubricate as
instructed in Maintenance Section.