TROUBLESHOOTING GUIDE
The following information is intended as an aid in determining if problem exists. For repair service, contact service
center in your area.
Symptom
Possible Causes
Corrective Action
Bead breaker not able to grip
the rim tightly.
• Oversize rim
• Tire is inflated
• Do not use on rims greater than 26"
• Completely deflate the tire
Erratic action
• External leakage
• Sticking or binding components
• Contact service center
Bead breaker not responding
to pressurized fluid
• Loose connections
• Faulty connections/ couplers
• Loose connections/ couplers
• Oil level in pump is low
• Pump not operating
• Tighten connections
• Replace connections/ couplers
• Tighten connections/ couplers
• Depressurize and fill the pump
• Check pump’s operating instructions
Bead breaker cannot close or
shovel extends only partially
• Oil level in pump is low
• Sticking or binding components
• Depressurize and fill the pump
• Contact service center
Bead breaker responds to
pressurized fluid, but does not
maintain pressure
• Pump or valve malfunctioning
• Seals leaking
• Check pump’s operating instructions.
• Contact
service center
Oil leaks
• Worn or damaged seals
• Contact service center
Bead breaker will not open;
Shovel will not retract or
retracts slower than normal
• Malfunctioning coupler
• Pump reservoir overfilled
• Damage internally
• Linkage binding
•
Depressurize
pump and hose, remove
bead breaker and replace coupler
•
Depressurize
pump and hose, remove
bead breaker, drain fluid to proper level
• Contact service center
• Clean and lubricate moving parts
Shovel will not
fully
extend
• Oil level in pump is low
•
Depressurize
pump and hose, remove
bead breaker, add fluid to proper level
5
MAINTENANCE
Important: Use only good grade hydraulic oil.
Do not
mix different types of fluid and
NEVER
use brake fluid, turbine
oil, transmission fluid, motor oil or glycerin. Improper fluid can cause premature failure of the jack and the potential
for sudden and immediate loss of load. Mobil DTE 13M or equivalent recommended.
Inspect the bead breaker before every use for cracks or physical damages, leaks, worn or missing parts. Do not use
the bead breaker with damaged or missing parts, or oil leaks
.
Lubrication
A periodic coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust.
Cleaning
1. Keep the hydraulic system as free of dirt as possible. When not in use, couplers or connections must be sealed
with dust covers.
2. Periodically check the bead breaker for signs of rust or corrosion. Clean as needed and wipe with an oily cloth.
Storage
When not in use, store the bead breaker with cylinder fully retracted.
