Save these instructions.
For your safety, read and understand the information contained within. The owner and
operator shall have an understanding of this product and safe operating procedures before attempting to use this
product. Instructions and Safety information shall be conveyed in the operators native language before use of this
product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with
the use and misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined in
this factory authorized manual, remove from service until which time it is clear.
Inspect before each use.
Do not
use if broken, bent, cracked or otherwise damaged parts are noted. If the jack has been or suspected to have been
subjected to a shock load (a load dropped suddenly, unexpectedly upon it), discontinue use until checked out by an
authorized factory service center. Owners and operators of this equipment shall be aware that the use and
subsequent repair of this equipment may require special training and knowledge. It is recommended that an annual
inspection be done by qualified personnel and that any missing or damaged parts, decals, warning / safety labels or
signs be replaced with factory authorized replacement parts only. Any jack that appears to be damaged in any way,
is worn or operates abnormally shall be removed from service immediately until such time as repairs can be made.
PRODUCT DESCRIPTION
Omega Air Actuated Hydraulic Bottle Jack with wheels is designed for
lifting
, but not sustaining, loads ranging up to
20 tons. After lifting, loads must be
immediately
supported by appropriate means. It is suitable for use in an
appropriately rated and designed vertical or bench press structure. This jack is
not recommended
for use in lifting
or positioning houses and/or other building structures. This jack complies with applicable
ASME / ANSI - PALD
Standards. For air actuated use, ensure that your air source can dedicate 7.8 CFM @ 90 - 175PSI to each jack
operated. To ensure dependable, troublefree operation an air dryer and oiler is recommended.
BEFORE USE
1. Verify that the product and the application are
compatible, if in doubt call Omega Technical
Service (888)332-6419.
2. Before using this product, read the operator's
manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use.
3. With the provided handle, open the release valve
(counter-clockwise no more than 2 full turns).
4. With ram fully retracted, locate and remove the oil
filler screw. This will help release any pressurized
air which may be trapped within the reservoir.
Ensure the oil level is just below the oil filler screw
hole. Re-install the oil filler screw.
2
SPECIFICATIONS
5. Pour a teaspoon of good quality, air tool lubricant
into the air supply inlet of the lift control valve. (See
Illustration) Connect to air supply and operate for 3
seconds to evenly distribute lubricant.
6. Check to ensure that jack rolls freely and that the
pump operates smoothly before putting into service.
Replace worn or damaged parts and assemblies
with Omega Authorized Replacement Parts only.
7. This product is fitted to accept the popular 1/4" PT
air nipple. When installing 1/4" PT nipple of your
choice, ensure that thread tape or compound is
used when servicing connections.
8. Inspect before each use. Do not use if bent, broken
or cracked components are noted.
Base Size (L x W)
Model
Capacity
Min. Height
Max. Height
20 Ton
6 7/8" X 4 7/8"
18 3/4"
18207
9 3/4"
