1-Button 2-Way LED
Remote Start Systems
QUICK START
OPERATION GUIDE
1-Button 2-Way LED
Remote Start Systems
QUICK START
OPERATION GUIDE
REMOTE START FUNCTIONS
FUNCTION
VALET BUTTON
NOTE
Pit Stop Mode
2
Press 2x after Engine Running For
More Than 10 Seconds
(Press 6x for XL mode)
This will leave the engine running for the programmed run time (XL mode runs for 12 hours) so you can take your
keys with you to run errands.
Low Battery & Low/
Hi Temp Auto-Start
Ignition Key ON, OFF, Press 2x
Auto-start will activate a max of once per 2 hours. See your installer or the full manual for threshold settings.
Valet Mode
2
Unlock, Hold For 3 Sec.
This disables remote start and the security system. The status LED will turn on. Repeat this process or press valet
button once to exit valet mode.
TIP: You can also enter valet mode by holding the valet button for 3 seconds!
OTHER 2-WAY CONTROLLER FUNCTIONS
FUNCTION
BUTTON(S)
LED
CONFIRMATION
NOTE
Low Car
Battery Alert
-
4 Beeps
Alerts when battery level is below 11.5v
for over 30 seconds.
Out Of Range
-
4 LED Flashes
When command response is not received
2-WAY CONTROLLER OPTIONS
FEATURE
PROCEDURE
Beep Volume
Hold
for 7 seconds.
Controller will scroll through:
Melody > Soft Melody > Silent
2
Scan to register
& download the
full operation
guide at
CarAlarm.com!
REMOTE START ERRORS
3
CHIRPS/FLASHES
VIOLATED ZONE
LED ON
System in Valet mode
1
Hood opened
2
Brake pedal pressed
3
Bad tach signal or engine over-rev.
4
BLACK/WHITE wire lost ground
5
3D motion detected while cranking
6
Received engine stop command
7
Alarm was triggered
8
Run time expired
9
Low vehicle battery voltage detected
3
2-These functions are only available on some remote start models. Consult your installer for more info.
TIP:
If remote start won’t activate, the system may be in valet mode
(Status LED ON). Press the valet button once to exit.
3-These functions are only available on some remote start models.
If the system fails to remote start or remote start stops unexpectedly,
it will give a long horn/siren chirp followed by a series of short horn/
siren chirps & light flashes. The short chirps/light flashes indicate
the cause of the failure.
MANUAL TRANSMISSION RESERVATION MODE
2
This must be performed before you can remote start a manual transmission vehicle to ensure the car is in neutral &
maximum safety. Consult your installer for more information.
1) With the engine running (more than 10 seconds), hold the brake pedal & place the transmission in neutral.
2) Apply the parking brake and release the brake pedal.
3) Send the remote start command via your remote. The remote start should engage
(not crank) and the status LED will begin flashing.
4) Take the ignition key out of the switch (the engine should stay running).
5) Exit the vehicle and lock your doors with the remote. The engine will turn off.
Status LED
Valet / Programming Button
WINDOW-MOUNT ANTENNA/RECEIVER
