7
Installer Programmable Features (cont’d)
Feature #9 Turbo Timer
Off
(press the brake pedal 1 time to program)
- DEFauLT
Run 1 minute
(press the brake pedal 2 times to program)
Run 2 minutes
(press the brake pedal 3 times to program)
Run 3 minutes
(press the brake pedal 4 times to program)
This feature when turned on configures the system to automatically keep the engine
running briefly after it is turned off. This operation is designed specifically for ve
-
hicles having turbocharged engines. This feature should only be programmed by the
installer, and the operation of this feature depends on the correct connection of the
neutral safety wire to the vehicle’s parking brake. Please refer to the “Black/White
wire” in the installation manual for the proper connection of this important wire.
Programmable Features matrix
User Feature Programming: Ignition on, off, press valet 5 times
# Feature
Brake Pedal x 1 Brake Pedal x 2
Brake Pedal x 3 Brake Pedal x 4
1 Engine Run Time
10 min
5 min
15 min
20 min
2 Steady/Flashing lights for RS Steady
Flashing
Installer Feature Programming: Ignition on, off, press valet 10 times
1 RS Activation
1 pulse
2 pulses
3 pulses
4 pulses
2 Engine Detection
Tachless Hi
Tachless Lo
Tach Wire
Datatach
Crank Only (Brake Pedal x 5)
3 Gas or Diesel Engine
Gas
Diesel
(15 sec delay)
Diesel
(20 sec delay)
Diesel
(30 sec delay)
4 Sat. Port Green Wire
Starter
Pulse After Start Status
Domelight
5 Crank Time
0.7 Sec
1.00 Sec
1.5 Sec
2.25 Sec
6 Low Temp Crank Extender
0ms
200ms
300ms
400ms
7 N/A
8 N/A
9 Turbo Timer
OFF
1 min
2 min
3 min
Feature #6 Low Temp Crank Extender
0ms (Off)
(press the brake pedal 1 time to program)
200ms
(press the brake pedal 2 times to program)
- DEFauLT
300ms
(press the brake pedal 3 times to program)
400ms
(press the brake pedal 4 times to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra
crank time to the base timing (see installer feature #5). It applies to tachless modes
only (installer feature #2)
