1010 Rowe St. Elkhart, IN 46516
(574) 295-5353 Fax (800) 367-3329
www.omeganationalproducts.com
The bottom slide has two large set screws at the front of the
slide that need to be adjusted to center the Pull-Out pantry unit
in the opening. Adjust these two set screws but do not tighten
them as the vertical adjustment must be completed by the lower
set screw on the bottom slide. Adjust so the front of the unit is
parallel with the face of the cabinet. The door opening can have
either the door mounted to the face (front) of the Roll-Out Pan-
try, or the door can be hinge mounted to the cabinet face frame.
Screws are provided for mounting the door to the Pull-Out
Pantry unit’s front panel. After mounting the door, complete the
adjustment of the lower slide and tighten the two side set screws
to lock the adjustment.
Safety Clip
Side to Side Adjustment
(Also holds Pull-Out to the Slide)
Vertical Adjustment
Form OME-074, 01/2009
©Omega National Products
©Omega National Products
To mount the lower slide assembly on the lower cabinet shelf,
the center line of the cabinet must be marked as a reference
line. Extend the slide unit to see the mounting holes along the
center of the bottom section of the slide. With the bottom section
positioned over the center line, with the line visible through the
mounting holes, position the slide so the front edge of the bot-
tom section touches the inside edge of the cabinet face frame.
Screw the lower slide assembly to the lower cabinet shelf with
eleven #8 X 5/8” Truss Head Phillips Screws. Be very careful
not to over tighten the screws and cause the screws to spin after
they have been brought up to tension.
You are now ready to assemble the Pull-Out Pantry unit onto
the slides. The Bottom slide must be fully extended and the
upper U-Profi le Guide Safety –Clip must be in the open posi-
tion. Refer to the Fulterer instructions for details. Place the
Roll-Out Pantry Unit on the extended lower slide assembly with
the Roll-Out Pantry positioned approximately 4 inches forward
of the normal extended position. As the unit is pushed back into
the cabinet, the lower slide will begin to engage and the upper
guide will need to be aligned as the guide wheels travel inside
of the Upper U-profi le Guide. As the unit is pushed to the back
of the cabinet, the slide will “skid” slightly and will require slightly
more force the fi rst time it is pushed closed. Pull the unit out far
enough to close the Safety Clip on the Upper U-Profi le Guide.