Step 4:
Remove the Waste and Recycle unit from the
cabinet and place on the cabinet door. Center
on the door side to side and measure for the
appropriate position vertically.
Step 5:
Mark the location of the slots and pre-drill a
1/16" hole and fasten to the door using 4 6
x 1/2" Washer Head Screws (see Figure 05).
Some adjustment of the door position can
be made by slightly loosening these screws.
Once the unit and door are satisfactorily
aligned proceed to Step 6.
Step 6:
When the door has been satisfactorily aligned
tighten the 4 washer head screws and insert at
least 1, 6 x 1/2" Truss Head Screw into each
mounting bracket to lock the position (see
Figure 06).
Figure 4
Figure 5
Form OME-096, 04/2018
©Omega National Products
Figure 6
Step 7:
With the Waste and Recycle Unit back in the
cabinet pull it out several times to check for
smooth action. A final adjustment can be
made to align the door with the front of the
cabinet by loosening the screws on the side of
the unit (see Figure 07)
Figure 7
Omega National Products
1010 Rowe St.
Elkhart, IN. 46516 USA
www.omeganationalproducts.com
