Step 6:
Attach the Mounting Brackets to the
Contempora Range Hood with 8 each #10
x 3/4" Pan Head screws. The flange of
Mounting Bracket should be to the inside (See
figure 6).
Figure 6
Step 7:
Remove the face plate and filters from the
Omega National Products Blower (not includ-
ed) and insert the blower into the liner from
the inside. Using the 4 holes in the side of the
blower that correspond to the holes in the liner,
attach the blower to the liner and rangehood
assembly with 4 each #6 x 1/2” screws. (See
figure 7).
Figure 7
Step 5:
If not installed after the Range Hood Was fin-
ished, attach the Liner to the Range Hood
with #6 x 1/2" Truss Head Screws (See figure
5).
Figure 5
Step 8:
Using help if necessary, lift the Range Hood,
Blower and mounting bracket assembly into
position and hang on the screws extend-
ing from the Mounting Board. Make sure the
brackets are firmly seated into the key hole
slot and then tighten all the screws (See figure
8).
Figure 8
Form OME-091, 05/2013
©Omega National Products
