5
2.3 DIP Switches on the iServer
For Dipswitch access you must remove the main board from the case. Refer to the
Disassembly Instructions in your iLD Big Display Monitor/Controller Quickstart Manual.
Figure 2.2 DIP Switches on the iServer
Table 2.1 Rear Panel Annunciators
Serial Communication Interface Section (For Models with RS485):
TB4 Pin 3
-Rx/Tx
TB4 Pin 2
+Rx/Tx
TB4 Pin 1
Return, Common Ground Shield connection
Network Communication Interface Section:
ETHERNET
RJ45 interface for 10BASE-T connection.
RESET
Button: Used for power reseting the iServer.
COL / ACTIVITY
LED (Red) Blinking: Indicates network activities (receiving or sending packets).
ON / NET LINK
LED (Green) Solid: Indicates good network link.
TX
LED (Yellow) Blinking: Indicates transmitting data to the serial port.
RX
LED (Green) Blinking: Indicates receiving data on the serial port.
1
4
3
2
OFF
ON
1
4
3
2
OFF
ON
The iServer is shipped with all DIP
switches in
"OFF"
position
1 To change the IP address
from the serial port
2 To change to default factory
settings
3 To enable/disable DHCP
4 To enable/disable Terminal
Server function
