Omega Engineering hot point CL900A Series, User Manual

Page: 13 / 28

3.2 Back Panel Connections
Figure 7. Back Panel
AC Power Input:
The customer connects the power cord to the AC Power Input. Refer to Section
4.3 for information on fuse replacement.
Power Switch
The power switch has two positions, "ON and "STANDBY."
Power Switch
The power switch has two positions, “ON” and “STANDBY.”
ON STANDBY
In the "ON" mode, the entire unit is powered up. The fan will turn on
immediately when entering the "ON" mode. Once the calibrator is no longer
being used and the switch is placed in the "STANDBY" mode, the unit is
powered down except for the fan circuit. The fan will continue to run for two
hours.
WARNING:
Do not disconnect the power cord from the unit while the unit is cooling down. Do not
disconnect the power cord until the unit has completed its cool down period. Never transport
the unit while it is still hot.
Operation
3
3-3
FINGER GUARD THERMAL RESET SWITCH VENT
FAN AC MAIN POWER INLET
AND FUSE COMPARTMENT
RS232 PORT