Omcan VP-NL-3016-SN, Instruction Manual

Page: 12 / 56

12
Operation
THE ONE-PROGRAM CONTROL SYSTEM PROVIDES ONLY ONE PROGRAM (P1)
• There is no memory to store additional values.
• The machine starts with the values that were most-recently used.
• The pump starts upon closing of the cover and stops when it is reopened.
PROGRAMMABLE FUNCTIONS
The following function values may be customized for P1:
• Vacuum time: in seconds.
• Sealing time: in seconds.
PROGRAMMING
1. Turn the machine on by pressing the on/off button.
a. The factory setting for the vacuum time is 30-40 seconds.
b. The factory settings for the seal time is 2 seconds.
REVIEWING VACUUM TIME AND SEALING TIME
1. Press the button to display the programmed vacuum time the vacuum time is pre-set at the factory.
2. Press the button to display the programmed sealing time the sealing time is pre-set at the factory at 2
seconds.
ADJUSTING VACUUM TIME FOR P1
1. Press twice on the or button.
- After pressing once, the programmed value is displayed.
- After pressing twice, the symbol will start blinking and the value may be adjusted.
2. Save the new value by pressing the menu button.
3. To retain the original value, press the button.
4. Exit the program by pressing the menu button.
ADJUSTING SEALING TIME FOR P1
1. Press twice on the or button.
- After pressing once, the programmed value is displayed.
- After pressing twice, the symbol will start blinking and the value may be adjusted.
2. Save the new value by pressing the menu button.
3. To retain the original value, press the button.
4. Exit the program by pressing the menu button.
TURNING OFF MACHINE
1. Turn the machine off by pressing the button.
2. The symbol on the display will start blinking.
3. Push the button a second time and the pump will stop immediately.
4. If no action is taken the pump turns off after 4 seconds.
5. Close the cover and the machine will initiate the cool-down phase and perform a number of vacuum cycles