14
Operation
8.
Press the menu button to save the entered values and to return to the Home menu.
TURNING PROGRAM FUNCTIONS ON/OFF
The following functions can be turned ON/OFF for each program P1-P9:
Vacuum Plus:
on/off, in seconds.
Gassing:
on/off, in seconds or in mbar (only with sensor).
Clean Cut Controlled (CCC) Seal:
on/off, in seconds.
Soft-Air:
on/off, in seconds or in mbar (only with sensor).
Multi-cycle:
on/off, in number of cycles.
ADJUSTING ON/OFF FUNCTION VALUES
1. Press the menu button to select the Settings menu.
2. Use the button to select the blinking function to be adjusted.
3. Press the button to select the desired value.
4. Press the button to reset all functions to their original values.
5. Select the next function with the button.
6.
Push the menu button to store all selected values and to return to the Home menu.
TURNING OFF MACHINE
•
Follow the same procedure as for the One-Program control system.
Maintenance
GENERAL
Regular maintenance prevents equipment malfunctions and prolongs the life of the machine. In addition, it
optimizes sanitary conditions.
• Always have a certified Henkovac dealer carry out repair and maintenance activities.
WARNING
•
During maintenance activities, always turn the machine off at the main switch and/or unplug it from the
electrical outlet.
ATTENTION
Observe the recommended service intervals. Overdue maintenance may lead to costly repairs and overhauls,
and may void the equipment warranty.
•
After reaching a programmed number of operating hours or packing cycles, the service symbol will
briefly appear on the display when the machine is started up. In addition, the display will indicate how many
hours or cycles remain before an oil change is required.
