Omcan Santos 55, Instruction Manual

Page: 10 / 24

10
Operation
Explanatory notes for the table: For example: you have made your grinding setting, which corresponds to
“Notch 6” on the grinding adjustment nut (5). If you want to obtain a 7g measure of coffee, you will need to set
the value of the timer to between 080 and 090 for an espresso type coffee.
The 2 selector buttons are set independently (fig. D).
The 2 “+” and “-” buttons (22) are used to increase or decrease the values and the “Selection” buttons (20 and
21) are used to confirm the timer values.
Pressing simultaneously on both the “+” and “-” buttons (22) for 2 seconds activates the “timer setting” mode”.
“1 XXX” appears on the screen (timer 1 value) and the “1 coffee” button (20) flashes (indicating setting of the
value of the 1 coffee timer)
• Pressing the “+” button increases the value by one unit.
• Pressing the “-” button decreases the value by one unit.
• Pressing either of the 2 “Selection” buttons confirms the value displayed and gives access to setting of the
timer “2”. The value of the timer “2” appears.
“2 XXX” appears on the screen (timer 2 value) and the “2 coffee” button (21) flashes (indicating setting of the
value of the 2 coffees timer).
• Pressing the button “+” increases the value by one unit.
• Pressing the button “-” decreases the value by one unit.
• Pressing either of the 2 “Selection” buttons confirms the value displayed, saves it and returns the machine
to the normal operating mode.
TIMER SETTING RANGE
No. 1 “1 coffee”: from 40 to 499
No. 2 “2 coffees”: from 80 to 999
The machine is set in the factory. You can initialise the factory parameters at any time.
INITIALIZING THE FACTORY PARAMETERS
1. Turn the machine off (On / Off switch (11) to the (0) position).
2. With one hand, press and hold down both the “+” and “-” adjustment buttons and then at the same time turn
the power on (On / Off switch (11) to the (1) position). A test procedure is launched at the end of which the
factory parameters are reinitialized.
If you release either of the buttons during the test phase, the initialization is cancelled and your settings
retained.