7
Operation
1. Set Temperature
•
Press the SET button, the set temperature is displayed.
•
Press the
or
button to modify and store the display value, press the SET button to exit and display
the cold room temperature.
•
If no button is pressed within 10 seconds, the cold room temperature will be displayed.
2. Illumination: Press
button, it lights. Press it again and it will stop.
3. Manual start/stop defrost: Press
and hold for 6 seconds to defrost or stop defrost.
4. Display Evaporation temperature: Press
button and hold for 6 seconds, the evaporation temperature is
displayed. After 10 seconds, the cold room temperature will be displayed.
5. Working LED: During the course of refrigeration, the LED is on. When the cold room temperature is
constant, the LED is off. During the delay start, the LED flashes.
6. Defrost LED: during defrosting, the LED is on. When it stops defrosting the LED is off. During the delay
display of defrost, the LED flashes.
7. Parameter Setup:
• Press the SET button and hold for 6 seconds to enter the parameter setup mode while E1 flashes.
Before using, the unit should be completely cleaned as it comes into contact with food.
1. Make sure that the main switch is in the (I) position, then plug in the unit.
2. Before starting the unit, ensure the sliding doors are properly closed.
3. Turn the main switch to the (I) position, the condensing unit will automatically start.
4. For lighting, press the lighting button. The lighting button is located on the thermostat.
5. If there is some condensation in front of the curved glass, please turn the switch to (I) position for
defogging.
6. Allow the unit to reach proper temperature before loading with product.
WORKING TEMPERATURE ADJUSTMENT
To reset the temperature inside the showcase, please follow as below:
CAUTION: You are suggested not to reset the temperature controller frequently.