Omcan PM-IT-0080, Instruction Manual

Page: 7 / 32

7
Installation
INSTALLATION, CONNECTION AND SET-UP
Install and use the machine in a room that can be efficiently ventilated, and where the floor is smooth and
compact and easy to clean.
WARNING: While the machine is operating, in order to obtain a product with the right thickness
and humidity, avoid air currents which will cause precocious drying of the product together with its
deterioration.
To assure machine stability, make sure that the wheels and feet are well positioned on the floor. Otherwise,
thicken the front feet, by helping yourself with the lifting lever.
WARNING: This thickening operation must be carried out by at least two people.
Position the machine in the desired place with a free back space of around 50 centimeters and a side space of
70-80 centimeters in order to guarantee easy use of the machine and its cleaning (Fig.20). When continuous
loading is foreseen, provide space for the mixer, elevator or manual loading as well. Check that the voltage
of the machine which is written on the identification label matches the one foreseen by the system on your
premises. Attach the right plug to the machine power cable in order to make the electrical connection to the
system.
WARNING: Have the plug fitted to the power supply by qualified personnel. Take the necessary
precautions to prevent the cable from being crimped or damaged.
INSTALLING THE CUTTING GROUPS
Both cutting groups must be installed. Unscrew the handwheel (Fig.21 A) with the plastic-moulded washer
(Fig.21 B), set up the group and block it with the handwheel, positioning the washer correctly. Insert the feeding
plug (Fig.22 A and B) to the group in the right machine outlet, note that the feeding tension are various and it is,
therefore, not necessary to modify the plugs (Fig.22).
CONNECTION TO THE WATER SYSTEM
The machine comes equipped with a cooling system of the extrusion sleeve; to connect the machine to the
water system (Fig.23) install the sending tube (Fig.23 B), (when it is non-existant: use a tap, possibly with
screw-control) to the outer part of the machine, in order to regulate the water flow. The exit-flow tube (Fig.23
A) must allow free water discharge. We recommend that the water pressure inside the machine, does not
exceed the 1.0 - 1.5 bar. To connect the external parts, use a flexible tube with an inside diameter of 13 mm,
safely fixed by a metal band with a screw that can be closed with a screw-driver or key (Fig.24). After inserting
the plug into the electrical socket the machine is ready to be used, after checking that all the elements of the
machine are operating correctly.